11
4. Easy Start
All the settings are done by SMS. Please use your cellular phone to send the following SMS to GC-101 to start experiencing
it.
1.
Request for the imei code of GC-101.
If the command has been transferred successfully, GC-101 will send an imei code to your cell phone otherwise a failure
message will be sent instead.
＃
username,0000,Imei
＊
2.
Set up APN (Access Point Name) that is provided by your GSM provider.
If you are not sure about your APN, please refer to the APN table in the CD or contact your local mobile phone service.
After sending the SMS command, GC-101 will response a message to your cell phone to see if the GC-101 does receive the
command.
Please note that the GC-101 is not able to determine the validity of the APN
.
＃
username,0000,3,your APN,user,password
＊
3.
Set up the phone book.
When either APN or URL is incorrect or GPRS/URL is not available, the GC-101 will not be able to upload the data to the
website. In any case mentioned above, the GC-101 will send a SMS instead containing GPS position to the 1
st
predefined
number.
＃
username,0000,5,cellular phone number*
4.
Set up Auto Report.
After sending the SMS command shown below with success, the GC-101 will start sending data to SANAV’s Website at the
interval of 60 seconds and total of 5 reports. However, if either GPRS is not available or APN is incorrect or URL is down,
the GC-101 will send the data via SMS to the 1st predefined number in the phone book.
＃
username
，
0000
，
6
，
60
，
5
＊
