47
3
2
1
주기 1 참조
4
RSU-7200 INSTALLER
( Φ10 X 25mm )
Stainless Nut (
Φ1
2 )
Spring Washer
( Φ1
2 ), Plain Wahser
( Φ1
2 )
Hexagonal Bolt
( Φ1
2 X 60mm )
Refer to No.1: Use less than 5mm in a Antenna fix-up panel.
In case of over 5mm, hexagonal bolt should be changed for installation.
Refer to No.1
48
5.3. DISPLAY SET-UP
5.3.1. Location for installation
Select the location for easy-investigation and maintenance.
5.3.2 How to Install
(1) Install the display according to the Block Diagram.
(2) Refer to the installation diagram.
5.3.3. Power Cable connection
(1) Connect a Power cable to [POWER] of the back-pannel.
(2) Connect an Aireal-cable to [ANTENNA] of the back-pannel.
(3) Connect an earth cable to [EARTH] of the back-pannel.
5.4. Installation check
After installation, check that all job has followed the instruction. The serious check points
are the cable connection, tight connection of each units, aireal-cable, the connection of
cable shield.
5.5. Operation check
(1) Before the operation check, it needs to check if the internal voltage is in an acceptable
voltage range.
(2) Check all parts of the radar in detail after operation check.
(3) Readjustment should be according to the manual even though the operation check is
O.K.
ATTENTION
※
A display must be installed 1 meter away from a magnet compass.
※
It may be harmful to the magnet compass in case of closer installation.