CHAPTER 4. MMC Programming
OfficeServ 500 Wireless LAN Service Manual/Ed.00
Page 4-4
© SAMSUNG Electronics Co., Ltd.
2 Programming
This section describes the MMC programming procedure related to the parameter
modification of the 8WLI and the WBS24.
The MMC related to the parameter modification of the 8WLI and the WBS24 are
listed below.
Table 4.2 Wireless LAN related MMC
MMC No.
MMC Function
845
Sets 8WLI, WBS24 parameter
846 WIP
INFO
847 8WLI
RESET/STATUS
848
Setting for the WIP Data terminals
849
8WLI Registration/Release, Encryption Settings
2.1
Setting the MMC845 8WLI Parameter
This MMC modifies the 8WLI parameter.
Set the network configuration with the 8WLI parameters, which are the SYSTEM ID,
the System KEY, and the WBS24.
The system KEY is used internally to distinguish between systems when registering a
terminal. The default value is ‘00000’, but only when this value is modified to
another value, an electric power will be supplied to the WBS24, thus enabling the use
of the WLAN terminal, In addition, the System KEY serves as an identification ID
when the WLAN terminal connects to the WBS24.
The default value of the SYSTEM ID, ‘WBS24’, must be modified to another value
in order to use a multiple system in one area. The DNS setting for WLAN is
additionally described in this menu.
Set the network configuration for eight WBS24s by setting the IP assignment, Netmask,
and Gateway for each WBS24. These settings should be compatible with the Intranet
since the network configuration setting is essential for data service. In addition, the RF
frequency for each WBS24 should be selected. Currently in Korea, up to 14 frequencies
may be selected.
The number of the WBS24 indicates the ID of the BTS for the WBS24. 1 to 24 are
assigned to the WBS24(Combo), and higher numbers than 24 are assigned to the
WBS24(Basic).
The WBS24(Combo) is connected to three WLIs. WBS24(Combo) 1 to 8 are
assigned to WLI 1 and WBS24(Combo) 9 to 16 are assigned to WLI 2.
Also, WBS24(Combo) 17 to 24 are assigned to WLI 3.
Session Initiation Protocol(SIP) variables used for the WBS24(Basic) can be defined.
