9
ASSEMBLING YOUR KEYSET
•
Place the keyset face down on a flat surface.
•
Insert notched ends of the support bracket into the channels located in the
upper section of the bottom panel. Push towards the top of the keyset to lock
in.
•
Plug the handset cord into the jack marked with the symbol.
•
Route the handset cord out the
RIGHT
side of the keyset as you look at it face
down.
•
Plug the eight-conductor
LAN
cable, from the wall, into the jack marked
LAN
on the back of the keyset.
•
Plug the eight-conductor
PC
cable, from the PC, into the jack marked
PC
on
the back of the keyset.
•
Plug the power connector, from the power adapter provided, into the power
jack on the back of the keyset.
•
OPTIONAL:
To connect a recording device, plug the device connector into the
jack marked
REC
on the bottom of the keyset.
IMPORTANT NOTE:
•
Be careful not to connect the Network LAN cable into the PC connector of the
phone.
•
To prevent damaging the keyset, only use the Power Adapter that came with
the 5012L keyset.
5012L.qxp 3/10/2005 10:47 AM Page 15
ITP-5012L SETUP
INITIALIZING THE ITP-5012L
Initially the ITP-5012L IP keyset will need to be setup to operate within the users
network.The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen via scroll button
will be highlighted.
The station numbers will be automatically set by the iDCS 100 Release 2 or the
iDCS 500 Release 2 system once the necessary information has been entered into
the IP keyset. Enter ID and password of the server, as described below to register
the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the ITP-5012L are:
•
IP Address of Station
•
Network Gateway Address
•
iDCS 100 R2 and iDCS 500 R2 MCP2 Server Address
•
User ID
•
Password
As soon as the ITP-5012L IP phone is connected to the power supply, press the
MENU
button and the LCD displays the
SETUP OPTIONS SCREEN
.
IP SETUP MENU
To enter the
IP SETUP MENU
, press the
MENU
button as soon as the ITP-5012L IP phone is con-
nected to the power supply. Unplug the power
from the ITP. Press and hold the
MENU
button
while plugging in the power, then release the
MENU button.
Once the
IP SETUP MENU
is displayed, you can move to each menu in the Set Up
by using the navigation buttons and
[1]-[9]
dial buttons of the ITP-5012L IP
phone.
•
The
UP
and
DOWN
directions buttons in the navigation button assembly are
used to move the highlighted bar up or down to the desired option.
•
The
LEFT
and
RIGHT
buttons in the navigation button assembly are used to
move the highlighted bar left or right, to the desired option, move to a sub
menu and if a menu is at the last line, that menu option will be executed.
Setup (1/6)
1.Information
2.Network
3.Load & Upgrade
4.System
5.Server
6.Exit
10
5012L.qxp 3/10/2005 10:47 AM Page 16
Содержание iDCS 500 Release 2/OfficeServ
Страница 50: ...N O T E S N O T E S ...
