Samson 5007-2 Series, Монтаж и эксплуатация

Страница: 64 / 72

16-6 EB 9511 EN
Annex A (configuration instructions)
Menu Adjustment range/values/description
Zero point ... .29 The zero correction allows the input value to be corrected by
±10 % at the maximum. The zero correction is always per -
formed before the span correction. The following functions are
available:
– Set zero: zero is set to the current input value (e.g. 3 %) and
the measured value is set to 0 %.
– Reset zero: zero is set to 0 %.
▪ Set zero (default), reset zero
The following values are displayed:
– Measured value (analog input signal) in %
– Currently adjusted zero
– Measured value (analog input signal) in mA
Span ... .30 The span correction allows the input value to be corrected by
±20 % at the maximum. Always perform a zero correction be -
fore the span correction. The following functions are available:
– Set span: span is set to the current input value (e.g. 103 %)
and the measured value is set to 100 %.
– Reset span: span is set to 0 %.
▪ Set span (default), reset span
The following values are displayed:
– Measured value (analog input signal) in %
– Currently adjusted span
– Measured value (analog input signal) in mA
Zero shift ... .31 Zero shift reading in %
Span offset ... .32 Span offset reading in %
Identification 2.3
Firmware version 2.3.1 Read the current firmware version of the SAM Connect Gate -
way
Serial number of the en-
tire device
2.3.2 Read the serial number of the SAM Connect Gateway
Serial number of option 1 2.3.3 Reading of the serial number of the option module in slot 1
Serial number of option 2 2.3.4 Reading of the serial number of the option module in slot 2
Serial number of option 3 2.3.5 Reading of the serial number of the option module in slot 3
Serial number of option 4 2.3.6 Reading of the serial number of the option module in slot 4
HW version/supply volt -
age
2.3.7 Reading of the hardware version of the voltage supply