www.reikalevy.fi
36
If cutting length is incorrect after adjusting the speed of feed conveyor, machine settings need to be
changed. Settings are located in the control panel service menu.
Encoder ratio is the ratio between feed conveyor angle sensor reading and cutting length. Encoder
ratio must always be 110.
Basic advance is used for fine-‐tuning the cutting length. Increasing basic advance shortens the cutting
length and decreasing basic advance lengthens the cutting length.
Sensor distance is the distance from photoelectric sensors to cutting unit. Changing the value only
affects the length of the first and last cut from the wood. Increasing the value increases the cutting
length and decreasing the value shortens the cutting length.
To access the service menu open
the menu from control panel.
Move selection to ”Service menu”.
Hold down joystick side button and
stop button (green arrows).
While holding down the buttons
press the button on top of the
joystick (red arrow).
