Samcon ExCam Series, Руководство по установке

Страница: 16 / 24

Doc.-ID: 180731-PT08BAU-SS-Ex Installation Manual rev.00.docx, Page 16 of 24
- At first, unscrew the stainless steel countersunk screw with internal hexagon (DIN
7991) on the flange component (see Fig. 6-5)
Fig. 6-5: Removing the countersunk screw, type T08-TNXCD
- Unscrew the cover flange with fine thread (M188X1.5) counter-clockwise ( ISO
metric screw profile, right-turning ). It is recommended to provide the outer
M8x1.25 threaded holes with screws, ring eyelets, etc., in order to facilitate the
screw driving. Attention: It may be necessary to lay and also rotate cable tails!
- Attention: Pull out very carefully and strictly vertically/perpendicularly the cover
flange with the multi-storey adapter, electronics printed circuit boards, PTZ mod-
ule, etc..
Danger of side tilting and damaging of the internal components!
Fig. 6-6: Opening the cover flange of type T08-TNXCD
- Ensure that the metric fine thread on the flange and camera body component is
not damaged! Risk of damage to the flame-proof threaded gap (DIN EN 60079-
1)!