12
•
SPS-300 Series Program Information
SPS-300 SmartECR Supplement v1.11
Flash ROM Update by SD
1.
Create a folder named
update
in the root of the SD card.
2.
Copy
SPS300.bin
to: SD:\update\SPS300.BIN.
3.
Insert the SD card into the register. (
The SD port is located inside the printer compartment.
Remove the security screw and open the flap securing the SD port. Insert the SD card until you
hear a click and the SD card is locked in.)
Boot Area Update
4.
At the SPS-300, turn the control lock to the
S
position.
5.
Power
OFF
the SPS-300.
6.
Press and hold the
Numeral 1
key on the keyboard. While continuing to hold the Numeral 1 key,
turn
ON
the power switch.
7.
A rapid beep-beep-beep will be heard. Release the Numeral 1 Key.
8.
The display the display will flash slowly at first and then will flash rapidly. When the load is
complete (about 5 seconds), a rapid beep-beep-beep will be heard again the display will stop
flashing and display a green color to confirm update completion.
9.
Turn the ECR power switch
OFF
and proceed directly to the next step: Application Update.
Application Area Update
10.
Set the control lock to the
S
position.
11.
Press and hold the
Numeral 2
key on the keyboard. While continuing to hold the Numeral 2 key,
turn on the power switch.
12.
A rapid beep-beep-beep will be heard. Release the Numeral 2 Key.
13.
The display will flash (Current program is being erased), after a few seconds, the display will
continue to flash, but at a slower rate. This continues for about 1-minute while the new program
is being loaded. When the load is complete, a rapid beep-beep-beep will be heard again the
display will stop flashing and display a green color to confirm update completion.
14.
Power the register
OFF
. The application portion of the update is now complete.
15.
Perform a
Memory All Clear
on the ECR. To complete the update procedure.