6 .1
AWRT10RF Pairing without Internet
Connection (AC10RF Coordinator)
Section 6
System Configuration without internet connection
Prior to using the AC10RF Coordinator on a system with no internet connection, update the
firmware version as follows:
1 . Use a computer with an internet connection that meets the following requirements:
2 . Go to the SALUS Software Tools web page:
www.salusinc.com/tools.html
3 . Download and run the Coordinator Update Tool to update the AC10RF Coordinator by
following the onscreen instructions .
4 . Insert the AC10RF Coordinator into a USB port on the computer when prompted to do so
After updating the firmware, insert the AC10RF Coordinator into the provided power adapter and
plug the two devices into an AC outlet . Verify that the LED is solid red .
Pairing with AKL01/04/06PRF and AKL08RF Relay Controllers
Before pairing, the AKL Series Relay Controller and optional AX10RF Receiver (if desired) must be
installed and powered in accordance with installation instructions included with these devices .
• The Network Status LED on the AKL Relay controller should be flashing and,
• if an AX10RF Receiver is used, the LED backlight on the Auto/Manual switch of this device
should be flashing red .
Step 1. Press and hold the lighted red button on the AC10RF Coordinator for 5 seconds until the
LED begins flashing, to begin pairing . When the network status LED on the AKL Wiring Center and
the backlight on the Auto/Manual switch of the AX10RF (if used) stop flashing, they have joined the
network and you are ready to pair the AWRT Wireless Radiant Thermostat .
COMPUTER
PC
Mac
OPERATING SYSTEM
Windows 8 or later
OSX 10.10 or later
USB PORT
Type A
Type A
If the network status LED on the AKL Wiring Center continues blinking, turn off the power to
the device for 10 seconds.
Содержание AX10RF
Страница 1: ...Wireless Controls System Guide As of December 31 2018...
Страница 4: ......