Salicru SLC Link Series, Руководство по обслуживанию

Страница: 17 / 141

- 16 -
7.7.3.- Connectors RJ-45 for ETHERNET networks (C12) and (C13).
• This connection is not necessary for the UPS operating, and it is only limited to the protection against transient voltages.
• Connect the input line (server side) of the IT network to the connector (C12) .
• Connect the output line (user side) of the IT network to the connector (C13) .
The ETHERNET network can become inoperative in case of doing an incorrect connection.
7.7.4.- Software.
7.7.4.1.-Basic structure for installing the «UPSMON» software
• PC with a free serial port (COM1 to COM4).
7.7.4.2.-Hardware installation.
• Turn OFF the PC and the monitor.
• Check that the basic structure is at least as stated in section 7.7.4.1
• Connect the cable between the PC (SUB-D9 male) and the UPS (SUB-D9 female). If the serial port in the PC is a male SUB-
D25, use a female SUB-D25 to male SUB-D9 adapter.
• Connect the PC (load) to the UPS , respecting the stated instructions.
• Start the UPS following the instructions in chapter 8. The UPS can be used as a central start-stop unit.
• Start the PC and the monitor.
• Before communications can be established between the UPS and the computer, the Config./COM serial port must be select-
ed and select the COM port to which the UPS has been connected too. The indicators of the panel of the «UPSMON» will be
visualised, and the parameters and conditions of the UPS will be shown in real time.
7.7.4.3.-«UPSMON» Software.
• The monitoring software is used together with the RS-232 interface to carry out control functions (diagnostic of voltage,
frequency, battery level, etc.) and to facilitate an ordered Shutdown by levels in case of mains failure.
7.7.4.4.-Software installation.
• Installation on Windows platforms.
ƒ
Insert the CD-Rom into the corresponding unit of the PC.
ƒ
The software installation will boot automatically, but if this property is not activated, just access the unit where the CD is
inserted and execute the file «Setup.exe».
ƒ
Follow the steps indicated by the software itself, answering the questions that will appear on the screen.
It is better to perform the installations as administrator user of the system or with equivalent permits.