Salicru SLC ADAPT Series, Руководство пользователя

Страница: 26 / 66

26
SALICRU
Installation of steel plates
1. As per the dimensions of the mounting holes of the base of
the cabinet, the steel plates should be spaced 702 mm or
more, and the space between holes centres should be 652
mm. The width of the steel plates should be 50 mm or more.
Determine the position for the installation of the cabinet on
the steel plates.
2. Drill holes through the mounting hole marks, diameter M10.
3. Move the cabinet to the installation position.
4. Use 10 x M10×45 bolts to line up the cabinet mounting
holes on the steel plates, and 10 nuts to tighten the bolts.
5.2.5. Installation of power modules.
The installation position of the power modules is shown in
Fig. 34. We take a 10-slot cabinet for 30 kVA modules as an
example, proceed in the same way for 50 kVA modules.
Install the power modules following a sequence from
bottom upwards to prevent dangerous tilting of the
cabinet due to the high centre of gravity.
The steps to install the power modules are as follows (taking as
an example a 10-slot cabinet):
1. Make sure that the cabinet is well secured to the floor and
insert the modules in the different slots provided for this
purpose.
2. Two people, one on each side, should hold the handle and
body of each module.
3. Insert the module into the slot and push it gently to the back
of the cabinet.
4. Fix the module to the cabinet using the mounting holes lo-
cated on both sides of the module’s faceplate (see Fig. 34,
on the right).
5. The installation of the power module is complete.
The procedure for the installation of the bypass module
for 6- and 10-slot cabinets is the same as for the power
modules.
Power
module
1# Power
module
2# Power
module
10# Power
module
A
Bypass
module
Bypass
module
10# Power
module
2# Power
module
1# Power
module
Power
module
Mounting holes
Zoom area A
Fig. 34. Installation of power modules.