Sakai SV410-2, Руководство оператора

Страница: 39 / 77

– 34 –
2.3.6 Stopping the engine
1) Gradually cool down the engine by running at low idle
for about 5 minutes.
IMPORTANT
• Do not bring a hot engine to a sudden stop except for an emergency. This will
shorten the life of its component parts.
• Do not allow an overheated engine to come to a sudden stop, but run it at middle
idling speed for gradual cooling down before shutting off.
2) Turn the starter key to the OFF position to stop the
engine.
CAUTION
Do not turn the starter switch OFF while the
machine is in motion.
3) Remove the starter key.
WARNING
• When dismounting from the machine, apply the brake by pressing the parking
brake button. If necessary to park on a grade, block the wheels to prevent
unexpected moving down the grade.
• Never fail to remove the starter key
2.3.7 Check after stopping the engine
1) Perform the walk-around checks for oil and water leakage, abnormal signs around the
drums.
2) Fill the fuel tank.
3) Remove waste paper if any from the engine compartment, as this will pose a possible fire
hazard.
4) Scrape mud or other materials from and around the drums.
OFF ON ST
AR
T
Idling
Full throttle
– 35 –
Vibration selector switch
Ⓑ
CONT.
Vibration switch
Vibration switch
Ⓐ
Idling
Full throttle
2.4 Vibratory Operation
1) Run the engine run on the full throttle by operating
throttle lever or higher by operating the throttle lever.
2) Amplitude of vibration is selectable and turned on and
off with the vibration switch
Ⓐ
located on control panel.
position: Turning the vibration switch clockwise causes
the vibration to start with high amplitude.
position: Vibration is shut down.
position: Turning the vibration switch counter clockwise
causes vibration to start with low amplitude.
NOTE: For vibratory rolling, run on full throttle.
Also, by means of vibration selector switch
Ⓑ
, the
selection can be made between the vibration switch
Ⓒ
installed to the Forward-Neutral-Reverse (F-N-R) lever
and the other one located on the panel.
position: Vibration can be turned ON or OFF with
the switch located on the Forward-Neutral-
Reverse (F-N-R) lever. Pressing this switch
causes the vibration to start and pressing it
again to stop.
This vibration switch on the lever should be
used with the vibration switch on the panel
placed at or position.
CONT position: Have this switch placed at this position when
vibration is not to be actuated.
3) Proper travel speed for vibratory compaction is 2 ~ 5 km / h, however, select speeds
depending upon job requirements.
IMPORTANT
• Keep the vibration shut off when the machine is not rolling.
• Stop vibration if the machine has encountered a running difficulty, for example,
when it gets stuck in the mud.
• Set the speed change switch in the LOW position during vibratory rolling
compaction. Use the HIGH position only for driving on flat straignt roads.
Vibration switch
Ⓒ