25
6.
Insert rotor assembly into feeder barrel rotating counterclockwise using crank
hub
K
and rod
L
while pushing with free hand. Make sure bearing seal at inlet end
plate does not pinch between rotor shaft and bearing race.
7.
Once rotor shaft enters the inlet end plate bearing, it might be necessary to use
a dead blow soft hammer to fit rotor all the way in the feeder while rotating it.
Push rotor as far in as possible with seals beginning to bend over on the side
against the inlet end plate.
8.
Install mounting bolts and tighten half way down — rotate rotor — tighten bolts
— rotate rotor — tighten bolts completely — rotate rotor.
Peer through outlet end plate to see if rubber seals break over against end plates evenly.
Adjust as required by rotating rotor and tap with dead blow hammer. Tighten set screws in bearing collars
when rotor is centered in the feeder barrel. Install drive components and any guards removed for service.
Discard old seals.
INDUSTRIAL ENGINE
Check the engine oil level daily before start up. Follow manufacturer’s recommended maintenance schedule
as specified in the engine manual included with the
Volu-Matic 200
manual. Keep the engine clean, especially
element type air filters and the air inlet cooling system.
Check that battery connections are tight and that cable leads are tight. If the battery is not maintenance free,
check the water level weekly. Make sure you use distilled water when replenishing a non-maintenance free
battery. Check that all exhaust connections are tight and that no leaks are present in the pipes or muffler,
replace as required.
L
K
Содержание CertainTeed Volu-Matic 200
