15
11.
For any problems encountered during preliminary start-up procedures, check the Troubleshooting section
or call CertainTeed Machine Works at 800-237-7841.
Warning: If at any time the drives do not stop when an emergency stop button is push in (off), or if any
swing gate is open, request that maintenance be performed on the safety interlocks.
VOLU-MATIC 200 RECOMMENDED START SETTINGS CHART
Note 1: Use these settings as a starting guide only. Variations between materials of the same type and
variations between batches from the same manufacturer may require different settings than those suggested.
Remember, the material manufacturer’s instructions prevail since they guarantee the final results.
Note 2: air pressure settings for side wall operation are for dense pack, net fill, and drill & fill of outside
walls of older structures. Spraying side walls will result in higher pressure based on water in the air stream.
GENERAL INSTRUCTIONS:
1.
Set the industrial engine speed or truck speed for machine operation. Reduce machine speed approximately
20 percent for side wall operation.
2.
Vary the air bleed pressure first. If you cannot get the desired results by opening or closing the air control
lever handle, then...
3.
Vary the slide gate next. If you cannot get the desired results by closing or opening the slide gate, then...
4.
Go to the next highest or lowest speed on the transmission. If you cannot get the desired results changing
the speed, then...
5.
Add or remove stator bar. If you cannot get the desired results by adding or removing the stator bar, then
start with varying the air pressure again.
OPERATION
MATERIAL
GATE SETTING
TRANSMISSION
GEAR
AIR BLEED
PRESSURE
Open Blow
Cellulose
16"
3rd
2.0 – 3.5 psi
Fiberglass
12"
3rd
2.0 – 3.5 psi
Rockwool
12"
2nd
4.5 – 5.5 psi
Side Wall
Cellulose
8"
1st
1.0 – 2.5 psi
Fiberglass
8"
2nd
1.0 – 2.5 psi
Rockwool
6"
1st
1.5 – 1.75 psi
Содержание CertainTeed Volu-Matic 200
