14
PRELIMINARY START-UP CHECKS
1.
Make sure hopper is free of foreign materials.
2.
Clear the area in front of the airlock feeder outlet
11
for testing.
3.
Move the toggle switch
9
to the center (off) position and plug
the remote cord
10
shipped with newly delivered machines into
the receptacle
7
. This is a twist lock connection.
4.
Put transmission into proper gear.
5.
Twist emergency stop buttons
4
&
5
out (on) and make sure
front guard is on for operation.
6.
On engine driven models, start the engine in accordance with
manufacturer’s literature and increase engine speed until the
throttle is at full speed. The engine should run at
3600 rpm
.
On PTO model machines, start the truck and engage the PTO
at a low idle in accordance with truck manufacturer’s literature.
Bring the truck up to the recommended speed established
during installation. Always engage and disengage the PTO
at a low idle.
PTO OVER SPEED WARNING:
The gearbox that powers the drive train on the machine is designed to run at a nominal 1500 rpm. This
speed should be held within 25 rpm so that machine components are operating at the correct design speed.
Over speeding the machine can and will damage shafts, bearings, and clutches driven by the gearbox, as
well as the gearbox itself.
This is especially true if the truck is moved before the PTO attachment is
disengaged after operating the machine.
Remember, the gearbox rotates at all times the PTO is engaged.
7.
Turn on the master switch
6
; light indicates the switch is on.
8.
Push reset button
3
on PTO models for next step.
9.
Cycle the toggle switch in the remote cord housing toward the cord and the blower will come on, check
that air does exit the airlock outlet. With the blower operating satisfactorily, cycle the switch toward the
end of the housing and the blower and machine mechanisms will operate simultaneously.
10.
Become knowledgeable about the components of the
Volu-Matic 200
machine. Engage and disengage
the remote cord noticing the drives start and stop. With machine running, push one emergency stop
button and check that the drives stop. Twist emergency stop button out, push the reset button and start
the machine again. Repeat the process opening the front guard. Push in the other emergency stop button
and check that the drives stop. If the remote toggle switch was cycled off, then cycle the toggle switch
for the drives to come on.
4
5
11
6
3
7
9
10
Содержание CertainTeed Volu-Matic 200
