Chapter 2: Installing the system
TT-98-129218-A
Installing the terminal
18
Installing the terminal on a bulkhead
Terminal with no cable support
Do as follows to mount the terminal on a bulkhead:
1.
Insert four screws through the holes in the mounting bracket and into the mounting surface. If
the mounting surface is used for grounding, make sure that you have a good electrical
connection to the surface.
2.
Connect all cables.
Terminal with Basic cable support
First mount the Basic cable support on the terminal as described in
Mounting the Basic cable
support
on page 17.
1.
Mount the terminal with the Basic cable support on the bulkhead by inserting four screws
through the holes in the mounting bracket and into the mounting surface.
2.
Connect all cables.
3.
Secure the cables to the cable support using cable strips.
Installing the terminal on a desktop
Four rubber feet make the terminal well suited for desktop installation. Simply place the terminal
on a desktop and connect all cables.
If required, fasten the terminal to the desktop with four screws, as described in the previous
section
Installing the terminal on a bulkhead
.
Make sure that the grounding requirements are met. See
Grounding and RF protection
on
page 55.
