Chapter 2: Installing the system
TT-98-129218-A
Installing the terminal
17
Mounting the Basic cable support
The Basic cable support is available from Thrane & Thrane.
When mounted on the terminal the Basic cable support offers a number of holders to which you
can secure the cables from the terminal, using cable strips.
To mount the Basic cable support, do as follows:
1.
Remove the two rubber washers from the bottom of the terminal at the connector panel end.
The threaded bushes underneath the rubber washers are used for mounting the cable
support.
2.
Fasten the Basic cable support to the terminal using two M4 x 6 mm countersunk screws.
3.
Install the terminal as described in
Installing the terminal on a bulkhead
on page 18 or
Installing the terminal on a desktop
on page 18.
