- 18 -
6. WARNINGS
EQUIPMENT DESIGNED TO BE OPERATED IN WELL VENTILATED ENVIRONMENTS.
KEEP WELL AWAY FROM ANY POTENTIALLY EXPLOSIVE ATMOSPHERE
7. USEFUL TIPS
- Before putting into operation and especially after
each cleaning and/or repair process, check that
the components of the equipment are perfectly
tight and that the hoses are sealed (without leaks).
You must replace or properly repair defective
parts.
- IT IS ESSENTIAL to have a differential switch
enabled for the power supply line of the PACK
6000X. Otherwise, have at least one 2-pole circuit
breaker (1P + N) installed.
- It is recommended outside working hours to
completely disconnect the power supply from the
PACK 6000X by directly removing the plug from
the plug or turning off the 2-pole circuit breaker (1P
+ N) on the main electrical panel.
- The PACK 6000X AIR HEATER equipment is
manufactured to achieve safety in use. Neverthe-
less during the use of the equipment hazards for
the operator or incidents may occur in the installa-
tion if the equipment is used by operators that are
not properly trained or instructed or it is not used in
accordance with the recommendations.
- Use it according to the usage, maintenance and
safety instructions in this manual and do the
practice applications required to achieve the
desired finish quality.
- The equipment is supplied depressurised
(without pressure inside).
- Use anti-static air hoses.
- Connect the equipment to a grounded power
supply.
- The total shunt resistance of the line must be
<100 million ohms.
- Carefully read and apply all the information,
instructions and safety measures indicated by the
manufacturer of the products to be used (products
to be applied, solvents, etc.), as these may cause
chemical reactions, fires and/or explosions or be
toxic, irritant or noxious and in any event
hazardous for the health and integrity of the user
and people around him (See section on Health
and Safety).
- The typical expected working regime is of up to
70ºC. This working regime is merely a guideline
and must be corrected according to the distance
between the equipment and the spray gun or
application tool (hot air consumption point) to
compensate for heat losses in this stretch.
- Switch off the heater after use to reduce electrici-
ty consumption and prevent the accelerated
deterioration of the heated hose.
- Use the lowest spray pressure in the spray gun
or application tool. That which allows you to obtain
the desired finish. Not all products require the
maximum pressure to be properly sprayed. With a
lower pressure one will obtain an additional
increase in product transfer.
- If you install a pressure regulator always mount it
before the PACK 6000X to avoid possible
overheating and dilation of the regulator. Set it to
the minimum pressure required to optimise the
performance of the PACK 6000X and save
energy.
- Please note that not all types of paint can be
applied with hot air and that this may even cause
imperfections in the paint finish.
Содержание 10780102
Страница 2: ......
