Sagem WP 1130, Инструкция по эксплуатации

Страница: 6 / 60

3
Installing the WP 1130
battery
plug
for the
connection of the
battery
battery full
low charge
battery empty
battery charging
Inserting the batteries into the handset
The handset is provided with a rechargeable NIMH
battery (3.6 V 400 mA).
Remove the lid of the battery compartment at the back of
the handset and insert the plug of the battery into the
socket on the left-hand side of the compartment.
Lay the battery cord carefully into the compartment and
then close the latter by sliding the lid.
State of charge of the battery
Recommendation: Charge the battery in the handset for
12 hours before using the telephone for the first time.
The battery symbol will light up continually if the battery is
sufficiently charged.
If the battery is only partially charged, the inner part of the
symbol will start to flash. This indicates that the battery is
almost empty and will soon have to be recharged.
Shortly before the battery is empty, the outer part of the
battery symbol will start to flash accompanied by an
acoustic symbol. This indicates that the battery has been
totally discharged und must be recharged immediately.
Charging the batteries in the handset
Place the handset into the charging cradle. The battery
symbol will flash as long as the battery in the handset is
being charged. It will stop flashing when the battery has
been sufficiently charged.
Positioning the base station
The mounting base can be attached in two ways
depending on the desired inclination:
Position 1: semi-inclined
The base rests on its short side.
Attach two self-adhesive feet to the base station and the
other two the mounting base.
Position 2: inclined
The base rests on its long side.
Attach the four self-adhesive feet to the mounting base.
Slide the two cords through the hole at the rear of the base
station.
Connecting up to the telephone network
Connect the telephone cord to the corresponding socket
with the following sign:
Plug the other end of the cord into the telephone outlet
box.
Connecting up to the mains supply
Plug the power supply unit into the socket bearing the
following symbol:
Insert the mains plug into the wall socket.
Only use the supplied power supply unit. Using another
power pack could cause damage to the device which is not
covered by the guarantee.
The WP 1130 is now ready for use.