Sagem WP 1130, Инструкция по эксплуатации

Страница: 16 / 60

13
MENU
MENU
MENU
Settings of the base station
Selecting the priority handset for incoming calls
If you have more than one handset, you can determine which
of the handsets will ring first in the event of an incoming call.
The other handsets will also ring, but with a slight delay. If you
prefer, all handsets can be programmed to ring at the same
time (Setting: Priority All ).
Press the MENU key several times until Telephone is
displayed.
Press the OK key to confirm.
Press the MENU key several times until Select Base appears.
Press the OK key to confirm.
Making Link will be displayed for a short period of time.
Wait until this message has disappeared.
If Making Link is displayed again, it means that the handset
cannot find a base station or that the base station has not
been plugged in. Try again.
Press the MENU key until the current setting is displayed:
Priority All or Handset .
Press the CHANGE key. Bs Pin? will appear on the display.
Enter the pin of the base station (default 0000).
Press the OK key to confirm.
If you have entered the correct pin, you will hear a confirming
signal. 1 2 - - - - -? will be shown on the display. The numbers
designate the handsets which are registered at the base
station (between 1 and 5).
MENU
Enter the number of the priority handset (e.g. 1).
If you have entered the incorrect pin, Wrong Pin will
appear on the display first and then the menu with the
priorities you can choose from.
Press the OK key to confirm. n Rings a nd Delay will
be alternately displayed (n is the number of rings which
is to be used as the delay).
Press the MENU key several times to increase the
number of rings (a maximum delay of 9 rings is
possible).
Press the SAVE key to save this setting. Handset will
then appear on the display.
Press the Back key several times or wait 20 seconds
until the telephone switches back into the idle condition.