INSTALLATION GUIDE
Page 37 / 46
3 000 068 637 éd04/ 542
How is the battery to be charged?
Using the base
• Place the PORTABLE on its base.
• Check to see if the electrical plug symbol is displayed on the portable screen
and if the battery symbol is moving (=battery charging).
Using the slave mini-USB connector of the portable
(The portable is out of its base)
• Connect the power supply unit to the BA-USB adapter. See §"Appendix, BA-USB
travel adapter".
• Connect this assembly to the slave mini-USB connector located on the side of the
portable. See §"Portable connections".
• Connect the power supply unit to the mains.
• Check to see if the battery symbol is moving (=battery charging).
11.6. ADJUSTING
THE
CONTRAST
If you wish to modify the contrast of the characters displayed on the screen, simply press and
hold the "Point" and " " or "Point" and " " keys as long as necessary to obtain a
satisfactory contrast.
11.7. INSTALLING A ROLL OF PAPER
Warning:
Use only paper approved by SAGEM Monetel.
Use of unsuitable paper is likely to damage the printer of your terminal.
Roll diameter: 40 mm.
1- If you are inserting a new roll,
tear off the
first length (one complete turn)
.
2- Open the paper recess cover plate
(figure 1a) as follows:
• Raise the catch located on the rear of
the EFT930;
• Grip the cover plate and tilt it down from
the rear of the terminal. (Figure 1b)
3- Insert the roll of paper in its housing
following the direction of movement shown
in figure 2.
4- Pull the paper up to the top of the terminal
(figure 2). Hold it in this position.
fig.1a
Catch
