INSTALLATION GUIDE
Page 29 / 46
3 000 068 637 éd04/ 542
6.
(DE-)INSTALLATION OF SAM1 AND SAM2
MODULES
SAM
1
SAM2
Caution
:
Switch off the machine before opening the cover
.
•
Open the battery compartment cover flap
(See § "Battery cover flap"):
you can read the location mark of SAM1 and SAM2
engraved in the lower housing.
•
When introducing a SAM in its slot, be sure to put the c
corner as indicated on the figure opposite.
ut
•
Close the flap cover.
Removing
Handy tip: use a piece of adhesive tape to grip the SAM to
make withdrawal easier.
7.
CAM2 COVER FLAP (SECONDARY READER)
CAM2 cover flap is located under the portable
Caution
:
Switch off the machine before opening the cover
.
7.1. OPENING
•
Turn the PORTABLE over on the table with the
bottom side facing up (figure opposite).
•
Unclip the cover flap by pushing simultaneously the
clips with your nails in the direction of the arrows 1
as shown opposite.
•
Lift the cover flap on the clips side (arrows 2) and
remove the cover flap.
7.2. CLOSING
To close up the device, carry out the above operations in the reverse order.
•
Engage the front of the flap cover under the terminal housing.
•
Fold cover backwards to clip it on.
•
Make sure the clips are totally engaged under the housing by pushing them manually.
