INSTALLATION GUIDE
Page 36 / 46
3 000 068 637 éd04/ 542
11.4. CONNECTING
THE
BATTERY
The battery pack is contained in the packaging carton.
On a new device, the battery pack is not connected.
1- Turn the PORTABLE over on the table with the
bottom side facing up and remove the cover flap
(See §" Battery cover flap")
2- Locate the battery
pack connector foolproofing
and the board connector located under the
battery compartment (figure 1).
3- Plug the battery pack connector on the board
according to the connector locating system
and the wire colors
(figure 1). Feel the locking.
4- Place the battery pack in its compartment
(figure 2).
5- Close the battery compartment cover flap.
= red wire
fig.1
fig.2
11.5. CHARGING
THE
BATTERY
When is the battery to be charged?
• On initial start up, charge the battery for 16 hours under the environmental
conditions stated above.
• When used daily the PORTABLE will recharge its batteries each time it is placed
on its base.
Charging is automatic.
A completly discharged battery requires 8 hours for a complete recharge.
Where is the battery to be charged?
• The environment in which the charge takes place influences battery lifetime and
autonomy (number of transactions out of base).
The optimal conditions are as follows:
-
charging away from any external heat source (radiator, sun, enclosed area…);
-
the optimal temperature is b15°C and +25°C.
