SAGA1-L Series
8
3-3. Receiver/Decoder Board for SAGA1-L8, L6, L4, L8B, L6B
Replacing this
Crystal
to Change
the frequency on
the receiver.
There are two kinds of
frequencies
VHF and UHF
are available marking with a
check is the current
frequency band and please
make sure not to replace a
VHF crystal unit into UHF
PC board or visa versa.
VHF:310.325~331.165MHz
UHF:425.5925~446.725MH
This terminal is used for
copier to read and write
data or connecting to PC
for function setting.
through software
.
SQ ADJ
is used for
a minimum receiving
sensitivity adjustment,
please don’t adjust
arbitrarily.
If necessary, adjusting
clock wise (allow
receiving a weaker
signal) until the SQ
lamp turns on, then
adjusting counter
clock wise (allow
receiving a stronger
signal) until the SQ
lamp turns off to keep
the SQ lamp at “off”
status before
operating.
The
SQ
lamp will turn on
when receiving any radio
signal. It was taken as
interference if the SQ
lamp didn’t at “off” status
before operating.
The receiving sensitivity
is adjustable via the SQ
ADJ.
The RX memory is
defective if the
Error
LED
flashes red every
0.5 second slowly.
Содержание saga1-l4
Страница 1: ...INSTALLATION OPERATION MANUAL...