Saga saga1-l4, Руководство по установке и эксплуатации, Страница: 16 / 23

SAGA1-L Series
15
7.0
TROUBLESHOOTING
Item Phenomenon Cause Action Required
1 Red LED flashing quickly
(every 0.2 sec.) when
any motion pushbutton of
Transmitter is pressed.
a) One of the pushbutton
is jammed.
b) The system is not
properly powered
according to the
instruction.
a) Replace the
pushbutton.
b) Power on
again according
to the instruction.
2 TX LED flashes red and
yellow reciprocally and
slowly (every 0.5 sec.)
The memory of the TX is
defective.
Send back the
Manufacturer.
3 RX Error LED flashes red
slowly (every 0.5 sec.)
The memory of the RX is
defective.
Send back the
Manufacturer.
4 The operating distance
Is shorter or an intermittent
operation is happened.
It was interfered by other
Radio Remote Controller
/or unknowing signal with
the same frequency.
Replace the crystal
of both TX and RX
to change the
frequency.
Remark: The memory of the TX and RX has Anti-copy function design, any
inadequate action on decoding the firmware of the memory will cause
the trouble as the above item 2 and 4.
Gain Electronic Co., Ltd. 01/2004 v.1.0
If any problem couldn’t be solved or any comments, suggestions please fax
to 886-7-8157253