Saga saga1-l4, Руководство по установке и эксплуатации, Страница: 15 / 23

SAGA1-L Series
14
6.0
ID-Code Remote Setting
ID-Code remote setting allows you to pair the new TX or RX if one of them is damaged.
In order to work the TX & RX must have the same frequency. Using ID-Code remote
setting will make both the TX and RX to have the same ID Code.
1). Please make sure the following conditions before ID-Code remote setting:
(a) Both TX and RX are of the SAME model and frequency.
(b) To place the transmitter as close as possible to the receiver to avoid any
interference.
(c) Turn off the RX power more than 10 seconds and turn it on again.
(d) Complete the ID-Code remote setting within 4 minutes after turning on the RX. The
RX will NOT accept the ID-Code remote setting signal after 4 minutes.
2). ID-Code remote setting Instructions:
(a) Press and hold the transmitter STOP pushbutton/EMS button.
(b) Press DOWN pushbutton and hold it.
(c) Press UP pushbutton 4 times and release “STOP & DOWN” pushbuttons when the
red light on the transmitter is flashing.
(d) Start the system as usual.
Note: For SAGA1-L6B
1. The DOWN pushbutton must be remaining in 1
st
step while holding the button.
2. Press UP pushbutton till 1 st step continuing for 4 times. Do not press button into 2 nd step
while processing this instruction otherwise the ID-Code remote setting will be aborted.
ATTENTION:
* In case ID-Code remote setting fails, repeat the instructions above within 4 minutes.
* ID-Code remote setting is available for ID Code only. It will not change function settings
* Within the operating distance, all same model systems on the same frequency will be
paired with the transmitters ID Code.
Press and hold the
STOP STOP STOP STOP pushbutton
Continuing press
the UP pushbutton
for 4 times
Press and hold the
DOWN pushbutton
Press EMS button
Press and hold the
DOWN pushbutton
Continuing press the
UP pushbutton for 4
times