Safex Tintschl Engineering FlowMarker, Инструкция по эксплуатации

Страница: 9 / 28

GA FM 1 03.05 • 22
/
CharGING ThE
BaTTErY
Maintenance anD caRe D
rEMOVING
BaTTErY
CharGING
BaTTErY
ExTErNal
FluID FIllING aND
TaNk
The battery is charged inside the device. The included power supply transfomer with
plug generates the necessary DC voltage. It is connected to the device with the inserted
battery via the power input socket (see figure 3). The power supply must be plugged
into a regular 100 - 240 V AC/50-60 Hz socket.
The battery is automatically charged, with the FlowMarker switched on or off.
After
two hours, 80% of the loading is done; after 3 hours, the battery is 100% loaded.
For frequent use, the device should regularly be connected to the power supply and, if
possible, remain connected over night.
For the maintenance of the battery which, unlike NiCd batteries,
has no memory effect,
it is of advantage to leave the device connected with the power supply over a longer
period of time, possibly for several years.
However, this “round-the-clock” loading mode only makes sense if the used
mains supply has no automatic “night cut-off”, as otherwise the battery would
be discharged.
IMPORTANT:
Please make sure that during storage or transport the fog button cannot
be inadvertently pressed, for instance by objects lying on the device.
If more than one battery is available, the device can be equipped with a fresh battery
in a short time.
loosen the battery compartment safety screw, hold the device upright with the nozzle
showing up, and slightly beat the edge of the battery compartment on the ball of the
thumb of your open hand until the battery loosens and slides into your palm.
The FlowMarker is designed for operation only with original batteries.
In addition to the possibility to charge the battery inside the device, a charging adapter
with power supply is available as an extra accessory. with it, you can charge spare
batteries independent of the device.
Put the clip of the charging adapter on the contacts of the spare battery, plug the power
supply into a regular (100- 240 V) outlet and charge the battery for at least 2, or better
3 hours.
remainders of the fog fluid in the tank can be kept there for up to 2 years without suf-
fering any harm. The pressurized can is also storable for at least 2 years. It should be
stored not below minus 15°C and at a maximum temperature of 30°C.
Due to its very fine construction details, the FlowMarker is very sensitive to dirt in the
fluid channels and in the fog fluid itself. Therefore, the fill opening and the valve of
the fluid can must be protected from fibres, fluff and any sticky liquids.
The fill stem of the fluid can must be covered with its cap. It can be cleaned with warm
water.
After every filling, clean the fill opening of remaining fluid with absorbent paper. Before
the next filling, clean the opening of dust and fluff with a soft brush or warm water. (All
case components are made of stainless steel).
Do not let any water get into the device.