SERVICE
Repairs
If your tool is damaged, call Safety Speed Cut at 800-772-2327 for technical advice or for the name of a dealer
near you who can service your machine.
Replacement Parts
Refer to the separate replacement parts information provided with the tool.
Alignment
The tool is aligned at the factory to a tolerance of:
•
±
1/32”, on Models C-4, H-4, H-5, and H-6
•
±
1/64”, on Models 3400, 6400, 6800, TR-2, SR-5, and SR-5U
•
±
.005”, on Models 7400 and 7400XL.
It needs realignment only if mishandled or abused, or if the motor or a roller is replaced.
Alignment consists of four steps that must be done in the following order (these steps are explained in detail
below):
1. Adjust the blade or bit so it is parallel with the guides.
2. Adjust the blade or bit so it will be perpendicular to the workpiece.
3. Adjust the guides so they are perpendicular to the rollers.
4. Align the rollers.
Constructing an Alignment Tool
For maximum accuracy, construct a test square to check the full movement of the saw.
See Figure. Construct the square using a 6-ft metal ruler and two 4-ft metal rulers. (Using the 3-, 4-, and 5-ft
measurements assures squareness.) Drill holes and attach the rulers with pop rivets or small nuts and bolts.
4’ Frame Support
4’
Line up on
36” mark.
5’
3’
6’
Figure 32: Field Alignment Tool
Use the 6-ft ruler to check squareness of the rollers. Use the 4-ft ruler to check squareness of the guide tubes or
rails. The tool also can be used as a giant square for layouts.
32
