
continued on next page.
E. Installing Rear-Facing
E-4
Installing Base with Vehicle Belts
Store LATCH Belts
You
MUST
store the LATCH
system when using the
vehicle seat belts. See
section D-7.
1.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Store LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
Place Base in Vehicle
Rear-Facing
Center the base in the
chosen seating position.
2.
Thread Vehicle Belt
Thread the vehicle lap
or lap/shoulder belt
combination through belt
path as shown.
With an ALR belt, pull the
belt all the way out before
threading the base.
3.
Tighten Vehicle Belt
Push down firmly on the
base and pull up on the
shoulder belt to tighten.
With a switchable retractor,
pull the vehicle shoulder
belt all the way out to
switch the retractor into
the ALR mode before
tightening. Feed the slack
back into the retractor
while tightening.
5.
6.
Check Vehicle Belt
Tightness
Grasp the base at the
belt path
with one hand.
Push and pull the base
from side to side, forward
and back. The base
should not move more
than 1 inch.
NOTE:
If base moves more
than 1 inch, try reinstalling
the base or try another
seating location.
45
46
Содержание Comfy Carry Elite
Страница 1: ......