Safety 1st Comfy Carry Elite, Инструкция по эксплуатации, Страница: 23 / 29

Check for Proper
Recline
Make sure level line on
side of carrier is level with
the ground. Adjust base if
needed. (see section C-2).
You may need to place
a large rolled towel(s) or
foam pool noodle(s) under
the front of the base to
achieve correct recline
angle. Check often to be sure padding is still in place and the
belt is tight.
DO NOT add a towel or pool noodle while the
footrest is being used.
To Remove LATCH Belt
From Vehicle Anchor
Remove carrier from
base. Press down firmly
on the base on the side
with the LATCH adjuster.
Press release button to release tension. Unhook LATCH
from bar by squeezing spring lever and twist hook.
Check LATCH Belt
Tightness
Grasp the base at the belt
path
with one hand. Push
and pull the base from side
to side, forward and back.
The base should not move
more than 1 inch.
NOTE: If base moves more
than 1 inch, try reinstalling the base or try another seating
location.
Hook LATCH to Vehicle
LATCH Anchor
Fasten one LATCH belt hook
to the anchor in the vehicle
seat located in the vehicle
seat bight. Repeat for other
side of child restraint.
3.
Tighten LATCH Belt
Push down firmly on the base
and pull up on the free end of
belt to tighten.
4.
To Attach Child
Restraint to Base
Align the pins on the side
of child restraint with the
slots on the back of the
base. Push down firmly on
the carrying handle and the
front of the child restraint to
lock child restraint to base.
You will hear a “click” when
it is locked.
6.
7.
5.
Failure to securely attach carrier to base can
result in serious injury or death.
8.
E. Installing Rear-Facing
43
44
Pull up on child restraint’s
carrying handle and front to
make sure the front of the
child restraint is locked to the
base.
NOTE: The back of the
child restraint can be
lifted slightly off the base, but the child restraint remains
securely locked to the front of the base.
The carrying handle can be in any position when installed in the
vehicle.