SAFEGREASE 2
MAXILUBE
MMAX1DEN.doc
30.05.2005 Rev. 1D
5 (9)
6. Remove the follower plate (2) from the bottom of the barrel with the help of the air gun
(28). Feeding pressure air through the central unit (3) under the follower plate loosens the
follower plate.
7. Lift the follower plate from the barrel with the help of handles.
8. Change the new lubricant barrel to replace the old one.
9. Press the follower plate tightly to the barrel on top of the lubricant. Ensure that air is being
removed under the follower plate and that the central unit of the follower plate is filled with
lubricant.
10. Place the lid on top of the lubricant barrel. Fasten the lid with wing screws on the lubricant
barrel.
11. Place the pump through the lid into the follower plate central unit. Ensure that the pump is
attached to the follower plate.
12. Connect the hose for pressure air, the pressure hose for lubricant and the tank hose to the
pump.
13. Remove pressure from the grease filter (8) with the help of venting screw which is located
in the filter plug.
14. Clean the grease filter and filter cartridge and replace them when necessary.
15. Switch on the power to the pumping center. Reset possible low level alarm by pressing the
"Alarm acknowledgement" button on the control unit.
16. Make a pumping center operation test run by pressing "Extra lubrication" button on the
control unit.
3.2.2 Maxilube-STA
Note
Numbers in brackets are part numbers of drawing 461993B.
1. Ensure that the surroundings of the pumping center are clean. Impurities in the system
prevent trouble-free operation and cause damage when reaching the lubrication point.
2. Switch off the power on the pumping center when changing the barrel.
3. Lift the rod of the low level switch (12) from the barrel.
4. Disconnect the pressure air hose (8), the lubricant pressure hose (19) and the tank hose
(3) from the pump (4).
5. Lift out the pump from the lubricant barrel and place it on the pump bracket (25) or on a
clean, e.g. plastic base. Be careful not to damage the suction part on the bottom part of the
pump.
6. Remove the lid (6) from the top of the barrel.
7. Lift the follower plate (2) from the bottom of the barrel.
8. Change the new lubricant barrel to replace the old one.
9. Press the follower plate tightly to the barrel on top of the lubricant. Ensure that air is being
removed under the follower plate.
10. Place the lid (6) on top of the lubricant barrel. Fasten the lid with wing screws on the
lubricant barrel.
11. Place the pump through the barrel lid and follower plate to the barrel. Lock the pump with a
barrel nut (7) so that the lower part of the pump is approximately 2 cm above the bottom of
the barrel.
12. Place the rod of low level switch (12) on top of the follower plate through the hole on the
lid.
13. Connect the hose for pressure air, the pressure hose for lubricant and the tank hose to the
pump.
14. Remove pressure from the grease filter (9) with the help of venting screw which is located
in the filter plug.
