SAFEGREASE 2
MAXILUBE
MMAX1DEN.doc
30.05.2005 Rev. 1D
1 (9)
PUMPING CENTER MAXILUBE
1 GENERAL DESCRIPTION
The pumping center is designed for pumping lubricant into the system.
2 DESIGN
2.1 Maxilube-ECO
Pumping center Maxilube-ECO is equipped with a lid set which is axially descending.
Note
Numbers in brackets are part numbers of drawing 461982.
The pumping center comprises of a hydraulic part (pos. 1), pressure air regulator (pos. 2) and a
barrel pump (pos. 3) and its additional equipment. The hydraulic part includes a solenoid valve
group (pos. 4), a directional valve group (pos. 5), pressure gauges (pos. 6) and a fixing plate
(pos. 7) including a bracket for the pump which can be used during barrel change procedures.
The pressure air regulator contains an air gun (pos. 8) for lifting the follower plate.
The pumping center can be controlled and monitored by an integrated control unit, with SMS-
messages or with external control. The control unit contains a user interface (pos. 9) and a
circuit board (pos. 10). SMS-control contains a GSM-modem (pos. 11) and an antenna
(pos. 12).
The pump is delivered with the following additional pieces of equipment: barrel lid (pos. 13),
follower plate (pos. 14), barrel low level switch (pos. 15) and grease filter (pos. 16).
Note
The follower plate is not used with grease or oils of NLGI 0, 00 and 000
classes.
2.2 Maxilube-STA
Pumping center Maxilube-STA is equipped with a lid set which is stationary.
Note
Numbers in brackets are part numbers of drawing 461992A.
The pumping center comprises of a hydraulic part (pos. 1), pressure air regulator (pos. 2) and a
barrel pump (pos. 3) and its additional equipment. The hydraulic part includes a solenoid valve
group (pos. 4), a directional valve group (pos. 5), pressure gauges (pos. 6) and a fixing plate
(pos. 7) including a bracket for the pump which can be used during barrel change procedures.
The pumping center can be controlled and monitored by an integrated control unit, with SMS-
messages or with external control. The control unit contains a user interface (pos. 8) and a
circuit board (pos. 9). SMS-control contains a GSM-modem (pos. 10) and an antenna (pos. 11).
The pump is delivered with the following additional pieces of equipment: barrel lid (pos. 12),
follower plate (pos. 13), barrel low level switch (pos. 14) and grease filter (pos. 15).
Note
The follower plate is not used with grease or oils of NLGI 0, 00 and 000
classes.
