SAFE HOME WS500S, Руководство пользователя

Страница: 17 / 112

www.safehome.dk
17
• The Sensor should not be placed in direct sunlight.
• Do not install the Sensor outdoors or behind partitions.
• If necessary, change to a different location for better RF performance
Room sensor can be mounted with either screws or double-sided tape.
IMPORTANT! The Motion Sensor is designed with a power saving program. The
Motion Sensor will remain inactive for 3 minutes after each detection. Thus, during
system set up, please bare in mind of this feature during system set up.
The sensitive of the motion sensor is adjustable. Change the setting by placing the
connector on either the “High”, “Middle” or “Low” position. When the sensitivity is set to
“Low”, more movement is required to trigger the sensor. It is recommended to set the
sensitivity to “Low” and perform a “Walk Test” (Described in part D). If the walk test result
is satisfactory, the sensitivity does not require further adjustment. If the walk test result
shows the sensitivity is too low, then you can change the sensitivity setting to “Middle” or
“High” accordingly. Please perform the walk test after changing the sensitivity setting.
C. Walk Test
After mounting the sensor at the desired location, it is important to perform a walk test in
order to determine if the sensor is covering the correct area (up to 6 m).
In order to adjust the monitored area, the
angle of the sensor can be adjusted. If you
want to monitor a small area, turn sensor
down to the floor. If a larger area is required
turn sensor max. 12° up. This provides maxi-
mum range.
Always disconnect the call unit or sirens before “walk test” is performed.
Go in to the area the sensor should monitor. If a red light does not appear in the sen-
sor, the angle should be adjusted. Perform “walk test” again after 3 minutes. Repeat the
process until your motion is detected. Please note that there should be no movement in
the area of 3 minutes before test.
Tips : The sensor must not be directed against direct sunlight may not be placed near
heat or cold units (Air-climate plants, fans, stoves, heaters, etc..), As this may cause false
alarms.