SAFE HOME WS500S, Руководство пользователя

Страница: 16 / 112

www.safehome.dk 16
B.Installing the Door/Window Sensor
• Attach the transmitting unit (the main unit) on a solid
surface such as the door or windowsill.
• Mount the magnet onto a moving surface such as a
door or a window.
• Send ago marked with “>/<”. These characters must
be level with each other.
• The transmitter and magnet must not be more than 5
mm apart when the door / window is closed.
• Make sure that the devices are installed correctly by
opening the door / window. When the contact is bro-
ken, the little lamp on the battery pack light briefly and
indicates that a change is detected. If the light does not
appear, the units are mounted too far apart.
C. Mounting with the Double-Sided Adhesive
• Ensure the mounting surface is clean.
• Peel back one layer of the protective film and attach it to the transmitter.
• Peel back the remaining layer of protective film and press the transmitter firmly in place
against the mounting surface until firmly attached.
• Repeat to attach the magnet.
4.2.2 Installing the Motion Sensor
The wireless alarm system comes with 1 sensor described as a passive infrared sensor
(PIR).
A. Powering up the Motion Sensor
Remove the battery cover; insert a 9V battery noting the
polarity as shown in diagram below; replace cover.
B. Installing the Motion Sensor
• First, determine the location of the Motion Sensor.
• The Sensor should not be easily accessible.
• The Sensor should be placed in the most vulnerable rooms or near key entry points.
• Place the Sensor on a sturdy surface between 1.8m to 2.4mm (6ft to 8ft) from the floor.
• The Sensor should not be placed near extreme temperature sources (ovens, stoves
etc.)