EN
DIGIWAVE
III
33
Input level of default
Reverse the signal failure of the cooling unit. Normally Open or Normally Closed. (si défaut
actif)
Manual commands
Manual wire advance speed(m/min)
Setting of the default wire speed by pressing the manual wire advance speed button on the
Wire Feeder.
Purge gas time
Setting of the opening time of the gas valve when the user presses the gas purge button on
the Wire Feeder.
User management
Page 27
Import/Export USB – Ethernet
Page 26
Counters
Page 37
Network
Network Status
Setting of the network status 5.
Network Configuration
Network configuration: DHCP or manual entry.
Network Hosts
Management of the network hosts.
6.2. AUTOMATION INTERFACE DECRIPTION
Configuration>Installation>Général
>Automatisation
The N1 interface distinguishes the following signals:
SIGNAL
SENS
TYPE
REMARKS
1
DCY*
CLOSE TO START WELDING
INPUT
TOR
OPTO-COUPLER, 5 V – 5 MA
2
RI**
CLOSE WHEN CURRENT IS DETECTED
OUTPUT
TOR
RELAY CONTACT, 2 A – 48 V
3
DEFAUT
CLOSE WHEN THERE IS NO DETECTED DEFAULT ON
THE POWER SOURCE
OUTPUT
TOR
RELAY CONTACT, 2 A – 48 V
* Cycle Departure ** Welding current detection
Figure: Wiring for N1 interface on connector J2
Installation configuration in automation level N1
When the N1 automation mode is enabled:
•
MMA and TIG menus are no longer available
•
A specific page to the automation level N1 is added to the MIG menu SETUP
•
ARC START (RI) and START CYCLE (DCY) signals are enabled
•
Only specific automatic welding cycles are available
You can activate the automation N1 and the mode of functioning of the
RI
output in the menu:
Configuration>Installation>General
.
The choice of active level for
DEFAULT
signal is defined in the menu: Configuration>Installation>Default.
DCY
: Cycle Departure
0V
RI
: Welding current detection
Default
Shared Default &RI
Ground
Содержание DIGIWAVE III Series
