EN
DIGIWAVE
III
17
Softstart
The softstart phase can be pre-set for the start of the weld, allowing a limited wire speed with
low energy.
Variables :
Temps de palier : T(s)
[0.00 ; 10.00]
Temps de transitions : T(s)
[0.00 ; 10.00]
Paramètres principaux de soudage du palier de Hostart/Softstart.
Note
: If the setting exceeds the capacity of the source, the curve appears red
Remark
:
With the
SYN
mode, the wire speed of the Hotstart / Softstart step is tuned relatively to the wire speed of the welding step (
∆ ±70 %
), the real
speed is shown for information in grey tint, and is directly tunable with the
MAN
mode: wire speed (m/min)
[1.0 ; 25.0]
.
3. Welding
This menu allows refining of the tuning of the welding step.
Remark
:
Once you’ve chosen the mode, the main welding parameters are actualized. It is then possible to tune the parameters of each mode directly from
the main welding tuning page.
Advanced Sequencer
(
+
)
Sequence the welding phase in two regimes 1 and 2, which can have different arc transfers: Flat or Pulsed.
The arc transfer of the regime 1 is the one selected on the synergy bar of the main welding tuning page.
Variables :
Arc
transfer regime 2: Transfer2
Main welding parameters of the regimes 1 and 2
The timing of regimes 1 and 2 are independent and allow tuning of a dissymmetrical cycle. T(s)
[0.1 ; 5.0]
Transit time
T(s)
[0.00 ; 1.00]
Intermittent mode
(
)
The welding is made intermittently by a succession of times ON and times OFF.
Variables :
Main welding parameters
The timings of step ON and OFF are independent and allow tuning a dissymmetrical cycle. T(s)
[0.5 ; 10.0]
Remark
:
You can choose to realize the hotstart only on the first time ON in the menu:
Configuration > Installation > Cycle.
Step mode
(
)
Bearing change by a short press on the trigger
Variables :
Step number [2 ; 4]
Main welding parameters of every step
Program call during welding
(
)
Once you activate this option, you can call programs with the trigger while you’re welding. See § 4.3. page 23. Program Management.
Remark
:
You can activate the program call out of welding in the menu:
Configuration > Installation > Cycle
Содержание DIGIWAVE III Series
