S.R.Smith rogue2, Инструкция по сборке и установке

Страница: 9 / 21

9
d. Next, insert the hardware through the holes in the bottom of the runway parts. Insert a
(#15) 3.5” Hex Head Screw with a (#17) Flat Washer though each hole as shown in
Figure 4. Fasten each screw using a (#17) Flat Washer, (#18) Lock Washer, and (#19)
Hex nut.
e. Go back and fully tighten the outside bolts before completely tightening the center bolts.
Tighten until the plastic surfaces come into contact and are secure. Do not over tighten
the hardware.
2.
Insert the slide legs into the leg sockets. See FIGURE C.
a. The two short legs go into the front sockets nearest the slide exit.
b. The shorter of the two longer legs goes into the socket on the inside curve of the slide.
c. Be sure to insert the end of the legs that do not have the pre-drilled holes into the leg
sockets.
d. Do not attach the legs permanently at this point.
e. Tape the legs to the leg sockets so that they will be held in place when turning the slide
upright.
3.
Insert the top of the slide
ladder all the way into the two
sockets in the slide. Use
clamps to temporarily hold the
ladder in place while the slide
is being turned upright. See
FIGURE D.
NOTE: The top
of the ladder is the end with
the side rails cut square.
FIGURE C
Guide slots
FIGURE D