S.R.Smith rogue2, Инструкция по сборке и установке

Страница: 10 / 21

10
4.
Carefully turn the slide with the legs and ladder upright for setup. It will be necessary for two
people to perform this to avoid damage to the slide.
5.
Place the slide at the desired location relative to the pool wall. See MANUFACTURER’S
PLACEMENT INSTRUCTIONS on page 19.
6.
Temporarily remove the clamps to make final adjustments to the ladder.
a. Make sure that the slide entrance is level from side to side while maintaining a height of
77” + 1/2” (1.9558 M + 12.7 mm) from the deck level, and a ladder angle of 15 deg.
(0.262 rad) with respect to the vertical. See FIGURE A for reference.
b. Reattach clamps to hold the ladder in place prior to drilling.
7.
Drill two 3/8” (9.5 mm) diameter holes through each of the ladder side rails using the holes in the
slide as a drill guide. See FIGURE E
Level left to right
And adjust clamps
DRILL 3/8” BIT x4
Places
17, 18, 20
17, 16
For SI: 1 degree = 0.017 rad
FIGURE E