S.R.Smith CYCLONE, Инструкция по сборке и установке

Страница: 9 / 12

9
ON-DECK MOUNTING INSTRUCTIONS
1.
Place the assembled slide on the deck relative to the pool wall. Ensure that the
exit flume clears any coping. Slide may be angled slightly providing all
dimensions are maintained as noted in the
Manufacturer’s Placement
Instructions noted in the following section.
2.
With the slide in its proper location, center punch or otherwise mark through the
(7) mounting holes at the bottom of the ladder and base so that a visible mark
is apparent on the concrete.
3.
Move the assembled slide aside to facilitate drilling of the anchoring holes.
4.
Using a power drill and a 1/2” concrete drill bit, drill the holes to a depth of 4”.
Use tape or a marking on the drill bit to ensure that the hole for the anchor is
drilled to the required depth. Maintain drill hole straight and perpendicular for
proper holding strength of anchor stud.
5.
Clear the holes of all debris. Assemble anchor with nut and washer so that the
top of the nut is flush with the top of the anchor. Move the slide over the holes
and insert the anchors. Drive anchor through the slide mounting holes so that
nut and washer are flush with the surface material.
6.
Expand anchor by tightening nut 3 to 5 turns. Once anchor is set remove nut
and install a lock washer, item #
(3), and retighten nut to a torque of 55 ft.-lbs.