S.R.Smith CYCLONE, Инструкция по сборке и установке

Страница: 7 / 12

7
ASSEMBLY INSTRUCTIONS
Tools Required
1. Ratchet handle
2.
9/16” deep socket
3.
9/16” wrench
4. 1/2" socket or wrench
5. 1/2" concrete drill bit
6. 1/4" drill bit
7. Phillips screw driver
8. Power drill
9. Lint free rag
10. Pistol-grip clamp (optional)
Gasket Installation
•
Clean the groove of the top runway section, shown below, with a damp clean rag and dry
•
Take the 2 feet of gasket provided with your kit and begin to peel back the paper. Make sure you
are not removing the adhesive itself from the gasket.
•
Take the exposed gasket & adhesive and begin at a top edge of the runway section groove.
•
While firmly pressing the gasket into the groove, intermittently press and remove more paper,
exposing adhesive, until you have used the entire gasket.
•
Properly installed, the gasket will extend from one side of the slide to the other and be centered in
the groove, front to back.
•
Continue to assemble your Cyclone as described on page 8, and ensure the gasket remains in
place as you handle the sections
.
FIGURE B
NOTE:
BE SURE TO APPLY ANTI-SEIZE TO ALL
FASTENERS TO PREVENT GALLING.
NOTE:
Use pistol-grip clamps as necessary to align the molded parts.
Top Runway Section
(11)
1. Clean the groove
2. Place Gasket into
Groove