S.R.Smith CYCLONE, Инструкция по сборке и установке

Страница: 11 / 12

11
MANUFACTURER’S PLACEMENT INSTRUCTIONS
PROPER ASSEMBLY, INSTALLATION, USE, AND SUPERVISION ARE ESSENTIAL FOR PROPER
OPERATION AND TO REDUCE THE RISK OF SERIOUS INJURY.
1. The critical dimensions for placement of the Cyclone are as shown in FIGURE F and FIGURE G.
A.
The slide exit runway surface shall not exceed twenty inches (20”) above the water surface
as shown in FIGURE F.
B. The slide shall be positioned so that all water flowing off the runway exit drops into the pool.
The recommended overhang is 4 inches.
C.
The minimum depth of water below the exit lip of the slide shall be three feet (3’) and
increase to three feet six inches (3’-6”) at Pt. A, which is a distance of four feet six inches (4’-
6”) from the exit lip of the slide as shown in FIGURE F.
D.
A minimum depth of three feet six inches (3’-6”) shall be maintained at a distance of nine feet
(9’) along the extended centerline of the slide from Pt. A. as shown in FIGURE F.
2.
A minimum clearance area in front of the slide shall be maintained at all times as
follows:
A. The minimum clearance distance on either side of the extended
centerline of the slide runway shall not be less than three feet six inches
(3’-6”) at a point no less than two feet six inches (2’-6”) from the exit lip of
the slide and extending a distance of
thirteen feet six inches (13’-6”) in
front of the slide as shown in FIGURE G.
B.
The minimum clearance area in front of a properly installed diving board
on an inground swimming pool is a minimum distance of three feet six
inches (3’-6”) on either side of the board’s centerline as shown in
FIGURE H. P
t. C extends a minimum distance of “C” from the tip end of
the board as shown in FIGURE H
. The width distance “W” on either side
of Pt. C is given in TABLE 1 and shown in FIGURE H.
FIGURE F
FIGURE G
DECK/COPING SURFACE
3' MIN.
EXIT
RUNWAY SURFACE
PLUMBLINE
20" MAX.
WATER LEVEL
ENTRANCE
Pt.A
13'-6" MIN.
9' MIN. 4'-6"
3'-6" MIN. 3'-6" MIN.