9
SBK-BYOS2 INSTALL | 0419
Copyright ® 2019 S.R.Smith, LLC All rights reserved. |
srsmith.com
I N S TA L L AT I O N I N S T R U C T I O N S
B YO S 2 S L I D E
STEP 3: ENTRY SECTION ANCHOR ASSEMBLY
Attach handrails first. Handrails are directional; the side with the 2 bends faces away from the pool. (Fig. 4)
The BYOS 2 Frame Support consists of 1 entry frame support, 1 right support arm and 1 left support arm. The
assembly is attached to the BYOS 2 Entry Section with the hardware kit BYOS2-101-SS. (Fig. 5)
Carefully turn the BYOS 2 Entry Section upside down (on cardboard) and sit the anchor upright into position
as shown. (Fig. 6 & 7)
Using 4 each 3/8”x1” bolts, attach the anchor to the entry section. Use a flat washer on each side of the part
and anchor. Pass the bolt through from the outside of part toward the underside and add a lock washer and a
nut to each bolt. Hand tighten only. Attach next flume section after entry and 20˚ anchor on the downhill side
of assembly.
Attach right and left arms as shown. The arms are attached at this point only to the entry frame support using
2 each 3/8”x1” bolts with flat washers, lock washers and nuts. Hand tighten only. NOTE: The other end of the
right and left arms attach to the 20˚ anchor as shown in Fig. 8 & 9. Hand tighten only.
FIG. 7
FIG. 8
FIG. 9
FIG. 4
FIG. 5
FIG. 6
ENTRY FRAME SUPPORT
ENTRY FRAME SUPPORT
2
1
AWAY FROM POOL
