S.R.Smith aXs2, Руководство пользователя и процедуры технического обслуживания

Страница: 7 / 24

700-3002-BC 10.18.2017
COMPONENT DESCRIPTION
The lift is made up of several components:
Base Assembly - Mounts to the pool deck and contains the turning elements of the lift.
Base Insert Stem - Slides into the square anchor sleeve that is installed on the pool deck.
Mast -
The main vertical component of the lift.
Actuator Arm - Primary lifting arm of the lift connects the mast to the seat arm and is raised by the
attached actuator.
Support Arm - Provides stability for the seat frame.
Seat Arm - Provides an attachment point for the seat assembly to the actuator and support arms.
Motor Enclosure (left & right) - ABS plastic cover shields base assembly components from weather.
When cleaning the enclosure, be sure to use a clean, soft, non-abrasive material.
Actuator - Provides the up and down lifting action.
Motor Assembly – Consists of a 24-volt motor and gearing.
Control Box - The LiftOperator unit controls all lift operations with touchpad buttons on the front panel
that are identical to the user hand set. Three cables connect to the bottom of the Control Box to enable
operation of the lift. The largest connector is for the hand control. Connector # 1 is for the motor cable
(red stripe). Connector # 2 is for the actuator cable (green stripe).
Touchpad Control –
The touchpad control arrow keys can be used in the
event that the hand control is out of reach or fails.
Simply press and hold the arrow for the desired
action for one movement at a time – Up, Down, Left,
Right. Releasing the Arrow stops movement.
Battery Level LED Indicators –
The Battery Level LED Indicators show battery
charge levels. The LED’s will illuminate when either
the touchpad control or the hand control is activated
and will stay lit for 10 seconds. At greater than 50%
the LED glows Green, at less than 50% the LED
glows Amber, and less than 25% the LED glows red
and indicates the battery requires charging. If the
battery level is less than 25%, do not operate the lift.
Remove the battery and fully charge before use.
Emergency Stop Button –
In the event of an emergency, or if you need to stop lift movement immediately, pressing the
Emergency Stop Button (red button on the control) will stop all lift movement. At the same time an
audible alert will sound for 10 sec. then pause for 5 sec. and then the sequence will repeat until
the button is reset by turning it in the direction of the arrows on the button (clockwise). The
Emergency Alert LED will also flash Red when the button is pressed and will remain flashing until
the button is reset.
CONNECTOR 1
(MOTOR CABLE)
CONNECTOR 2
(ACTUATOR CABLE)