1
Right Side
Column
INTRODUCTION—DOOR SERIAL NUMBER(S)
INTRODUCTION
The information contained in this manual will allow you
to install your Rytec PredaDoor NXT
®
Door in a manner
that will ensure maximum life and trouble-free
operation.
Any unauthorized changes in procedure, or failure to
follow the steps as outlined in this manual, will
automatically void the warranty. Any changes to the
working parts, assemblies, or specifications as written
that are not authorized by Rytec Corporation will also
cancel the warranty. The responsibility for the
successful operation and performance of this door lies
with the owner of the door.
IMPORTANT: When installing multiple doors
of the same model but in
different sizes, verify the serial
number on the control panel
with the one on the side column.
Left Side Column
Drive Motor
DO NOT OPERATE OR PERFORM MAINTENANCE
ON THIS DOOR UNTIL YOU READ AND UNDER-
STAND THE INSTRUCTIONS CONTAINED IN THIS
MANUAL.
If you have any questions, contact your Rytec representative
or call the Rytec Technical Support Department at 800-628-
1909. Always refer to the serial number of the door when
calling the representative or Technical Sup- port. The serial
number plate is located on the small edge of the left side
column. (See Figure 1.)
Rytec
System 4
Control Panel
Serial Number
Location
NOTE: Left side column shown.
Figure 2
HOW TO USE MANUAL
Throughout this manual, the following key words are
used to alert the reader of potentially hazardous
situations, or situations where additional information to
successfully perform the procedure is presented:
Serial Number
Decal
A7700034
Figure 1
The wiring connections in this manual are for general
information purposes only. A wiring schematic is pro-
vided with each individual door specifically covering the
control panel and electrical components of that door.
That schematic was shipped inside the control panel.
DOOR SERIAL NUMBER(S)
Your
DOOR SERIAL NUMBER
information can be
found in three universal locations. These are at the
small edge of the left side column (shown in figure 1), on
the drive motor, and on the System 4 control panel.
(See Figure 2.)
WARNING is used to indicate the potential
for personal injury, if the procedure is not
performed as described.
CAUTION is used to indicate the potential for
damage to the product or property damage, if
the procedure is not followed as described.
IMPORTANT: IMPORTANT is used to relay information
that is CRITICAL to the successful
completion of the procedure.
NOTE: NOTE is used to provide additional
information to aid in the performance of
the procedure or operation of the door, but
not necessarily safety related.
