11
INSTALLATION—ENCODER
Install the encoder
1. Locate two (2) M10 x 25 hex screws in the small
parts hardware bag. Also, locate the two hex
mounting screws for the wireless antenna, which
are in the bag taped to the antenna mounting
bracket. You will need them for the next step.
2. Slide the encoder and white mounting bracket over
the encoder magnet. (See Figure 26.) Make sure
the wireless antenna is supported during this step
so that excess tension is not put on the connecting
wire.
Figure 26
3. Install and tighten the two screws.
Install the wireless antenna
The wireless antenna is fragile.
1.
Lift the wireless antenna assembly into place and
install the two hex mounting screws
(See Figure 27.)
Figure 27
Wire the encoder to the System 4 controller
1. Locate the encoder cable in the small parts box
and connect to the encoder.
2. Route the encoder cable to the System 4 controller
and connect per the provided schematics.
