Press DOWN firmly on the cutter shaft lock. While holding the lever down - rotate the cutter by hand until
the cutter shaft lock “clicks” in to position. When turning the cutter by hand there is only ONE locking
position to be found. Once the cutter shaft lock is fully depressed - Hold it There. You may now proceed
with removing the cutter shaft lock nut and the cutter.
PLEASE . . . DON’T FORGET
to pull UP on the cutter shaft lock when you are finished reinstalling the
cutter wheel. Pulling UP on the cutter shaft lock releases the cutter and the cutter shaft from the locked
position. Failure to unlock the cutter when attempting to cut a key may result in no rotation of the cutter.
Please note
- the motor may be powerful enough to slip the belt and permanently damage it by wearing a
flat spot on the belt.
13.
REMOVING/REPLACING THE CUTTER
REMOVING THE CUTTER
The cutter wheel is secured to the cutter shaft with a
LEFT-HAND NUT.
You must turn the nut to the
RIGHT
(facing the cutter wheel) to remove it.
9
FIG. 13
RY
20
03
0 CU
TTER
I N C O R P O R A T E D
UNDO
LEFT-HAND THREAD
