background image

7

English |

 

Original instructions

Even when you use a generator correctly, CO may leak into 

the home. Always use a battery-powered or battery-backup 

CO alarm in the home.

If you start to feel sick, dizzy, or weak after the generator 

has been running, move to fresh air immediately. See a 

doctor.
You could have carbon monoxide poisoning.

 

 WARNING

Do not allow familiarity with products to make you 

careless. Remember that a careless fraction of a second 

is sufficient to inflict serious injury.

 

 WARNING

Do not use any attachments or accessories not 

recommended by the manufacturer of the product. The 

use of attachments or accessories not recommended 

can result in serious personal injury.

APPLICATIONS

This generator is designed to supply electrical power for 

operating compatible electrical lighting, appliances, tools, 

and motor loads.

BEFORE OPERATING THE PRODUCT

 

Only use outdoors and far away from windows, doors, 

and vents.

 

Never use inside a home or garage, even if the doors 

and windows are open.

 

Always position the generator on a flat firm surface.

 

Check engine lubricant level and fill, if necessary. 

Refer to the "Checking/adding lubricant" section in this 

manual.

 

Check fuel level and fill, if necessary. Refer to the 

"Checking/adding fuel" section in this manual.

 

 CAUTION

Attempting to start the engine before it has been properly 

filled with oil will result in equipment failure.

SPECIAL REQUIREMENTS

Please consult a qualified electrician, electrical inspector, 

or the local agency having jurisdiction:

 

In some areas, generators are required to be registered 

with local utility companies.

 

If the generator is used at a constuction site, there may 

be additional regulations which must be obsereved.

USB CHARGING OUTLETS

The USB outlets will charge most USB-compatible devices.

 

For MP3, cellphones, and other small USB devices (up 

to 1.9 A), connect to the top USB port.

 

For tablets and high-charging current devices (up to 2.1 

A), connect to the bottom USB port.

NOTE:

 The USB oulets provides power only; it does not 

provide any communication capabilities. A suitable USB 

cable must be provided by the user.

CHECKING/ADDING LUBRICANT

See Figure 3.

 

 CAUTION

Attempting to start the engine before it has been properly 

filled with oil will result in equipment failure.

Engine  lubricant  has  a  major  influence  on  engine 

performance and service life. For general, all-temperature 

use, SAE 10W-30 is recommended. Always use a 4-stroke 

motor lubricant that meets or exceeds the requirements for 

API service classification SJ.

NOTE:

 Non-detergent or 2-stroke engine lubricants will 

damage the engine and should not be used. 

 

Place the engine choke/off selector knob in the "off" 

position.

 

Place the main on/off switch in the "off" position.

 

Loosen the screws at the side of the engine cover. 

Remove cover and set aside.

 

Unscrew the oil cap/dipstick and remove.

 

Wipe dipstick clean and re-seat in hole; do not re-

thread.

 

Remove dipstick again and check lubricant level. 

Lubricant level should fall between the minimum and 

maximum marks on the dipstick.

 

If level is low, add engine lubricant until the fluid level 

rises between the minimum and maximum marks on the 

dipstick. 

 

Replace and secure the oil cap/dipstick.

USING FUEL STABILISER

Fuel gets old, oxidizes, and breaks down over time. Adding 

a fuel stabilizer (not included) extends the usable life of fuel 

and helps prevent deposits from forming that can clog the 

fuel system. Follow fuel stabilizer manufacturer’s directions 

for correct ratio of stabilizer to fuel.

 

Mix fuel stabilizer and fuel prior to filling the tank by 

using an approved fuel container and shaking gently to 

combine.

NOTE:

 To control the amount of fuel stabilizer being 

added to the engine, always mix fuel stabilizer with fuel 

before fueling the tank rather than adding fuel stabilizer 

directly into the generator’s fuel tank.

 

Replace and secure the fuel tank cap.

 

Start and run the engine for at least 5 minutes to  allow 

stabilizer to treat the entire fuel system.

Содержание RIG2000PCB

























Отзывы: