7
ASSEMBLY
MOUNTING GUIDE BAR AND CHAIN
The unit is delivered with guide bar and saw chain
separated. Install guide bar and chain as follows:
WARNING.
Do not start the engine until
the saw is fully assembled. Wear
protective gloves at all times when
handling the chain.
1. Unscrew the two bar fastening nuts situated
next to the chain tensioning screw. (Fig.1)
2. Remove clutch cover by pressing the back end
of the cover and pulling it off simultaneously.
3. Attach the bucking spikes to the front of the
saw body so the spikes point upward. (Fig.2)
4. Slip the bar under the edge of the clutch and
then over the mounting studs. (Fig.3-A)
Note the position of the tension adjusters hole
in the bar (Fig.3-B). This hole will need to be
lined up with the tension adjustment pin when
the clutch cover is refitted.
5. Lay the chain around the sprocket (Fig.4-A)
Check that the tangs of the chain links are
sitting correctly in the slots in the sprocket and
then lay the chain around the bar.
NOTE:
The cutting edge of the chain must face
in the direction indicated. (Fig.4-C)
WARNING.
Before using a new chain /
bar for the first time liberally lubricate the
chain and bar by hand using chain oil.
WARNING.
Check that the
chain brake is released
before proceeding. The
clutch cover cannot be
removed until the chain
brake is released. Do this
by pulling the front hand guard towards the
choke lever - CHAIN BRAKE RELEASE
POSITION.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
B
A
B
A
C
Содержание CS-4016
Страница 17: ...17 MAINTENANCE petrol petrol...
Страница 18: ...18 NOTES...
Страница 19: ...19 NOTES...