pSEE™ Software
- 15 -
661850-001
Changing the Camera ID
The camera ID can be changed to suit an installation with multiple cameras on a single RS485
communication bus. By setting each camera to a unique camera ID, each camera can be
controlled independently from a suitable controller. The camera ID is changed through a
command entered manually in the Manual Commands tab.
Figure 12: Changing the Camera ID
NOTE: Additional configuration may be required in third-party controllers and matrix switchers
to accommodate this change. In order to avoid confusion, it is advised to connect each camera
on its own directly to a computer to set camera IDs. Once this is complete, place the cameras
into a larger installation.
To change the cameras ID (factory default is set to 1) use the Send Command field in the Manual
Commands tab enter the following command:
88 30 AB FF
Where AB is the hexadecimal camera address.
As an example, to set the camera ID to 24 the AB parameter is hexadecimal 18.
88 30 18 FF
NOTE: Camera ID 08 is reserved for the system. ID 0 is not used.
Contact RVision support at
to request Camera API which lists the
supported commands.
Содержание Thermal FFV
