Control
settings
19
•
To prime the pipework in between the pump units and the heads after
installation, use the 4 quick access buttons below the display to prime
outputs 1, 2 ,3 or the base independently. See next section.
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to change the option to
.
Press the Enter button to start the priming function.
The pump unit will pump at full power for a short time to purge air from the pipes
inside the unit.
To exit this menu if you decide not to activate the Prime function, select
and
press Enter.
Priming system with Quick access buttons
The four quick access buttons below the display are used for priming the system.
The three left hand buttons will prime the outputs to heads 1, 2 and 3
independently. This is used to expel air from the pipes between the pump unit
and the heads after installation. Priming continues while the buttons are held
down and stops when the buttons are released.
The heads must be in “Ready” state for the output prime function to
operate. Keep the button held down until fog/haze is produced from
the head.
The right hand button runs a timed sequence to prime the base unit and is
normally used when replacing fluid. This will also reset the Fluid Out error.
The heads do not need to be in “Ready” state for the base prime function to
work, and no fog/haze will be produced.
Res etti ng options to factory setti ngs
The factory settings configure a standard mode of operation for the system.
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to change the option to
.
Press the Enter button to reset all options.
To exit this menu if you decide not to reset the options, select
and press Enter.
